CRM Mitchell1, Author at Chicago Driveline Inc

2010 Subaru Forester
Mileage
86,328
Service Date
7/2/2021
Services Performed
AFTER CHECKING VEHICLE WITH SCANNER FOUND NO CODES IN SYSTEM AT THIS TIME. CUSTOMER ADVISED TO WATCH FOR ENGINE LIGHT OR CHANGE IN RUNNING CONDITIONS.
Changed Motor Oil & Replaced Filter, Added 4 QTS Blended Motor Oil, Lube Chassis, Check all Fluid Levels
Tony D. gave our service a 5 star review on 7/4/2021
2009 Honda Accord
Mileage
135,711
Service Date
6/29/2021
Services Performed
After test driving NO Engine light was present at that time we then scanned vehicle for possible codes and found two pending po497 and p145c evap system codes. We cleared and drove vehicle again and still no Engine light or codes. Customer advised we rec light to be on when testing Engine light concerns.
CK ALL BRAKES MAKING NOISE
INSTALL FRT PADS / ROTORS
INSTALL REAR PADS / ROTORS
Remove Tire from Vehicle, Inspect & Repair as Nec. Found nothing stuck in tire we cleaned and sealed tire and Rim.
Winston C. gave our service a 5 star review on 6/30/2021
2006 GMC Envoy
Mileage
206,134
Service Date
6/28/2021
Services Performed
Test drove vehicle and inspected on hoist. Was unable to duplicate customer concern of clicking on turns while on test drive. Found the RF axle appeared to be worn out and had junk yard type markings on the axle. Recommend replacement of axle and recheck for clicking noises on turns.
Changed Motor Oil & Replaced Filter, Added 4 QTS Synthetic Motor Oil, Lube Chassis, Check all Fluid Levels
Rotate Tires
Test drove vehicle and inspected on hoist. Check engine light was not on at time of inspection. Scanned for codes and found P0014- exhaust camshaft position system performance. Inspected circuits and connections and found no faults. Inspected engine oil level and condition and found engine oil level was ok, was black in color and due for replacement. Tested and found proper power and grounds to camshaft actuator. Removed actuator and found debris on oil inlet screens. Recommend replacement of camshaft position actuator, changing engine oil and filter, clearing codes, and rechecking system operation.
VARIABLE VALVE TIMING SOLENOID – Remove & Replace – In-Line6 – [NOTE: Labor estimates listed are for R&R only and DOES NOT include diagnosis time.]
The Carbon Clean System is a technologically advanced method for cleaning and de-carbonizing harmful fuel system contaminants from gasoline engines,Clean Throttle body And Fuel Tank Additive.
INSTALL FRT PADS / ROTORS
INSTALL REAR PADS / ROTORS
SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – Both – [DOES NOT include disassemble or alignment (where applicable).]
REAR SHOCK ABSORBER – Remove & Replace – Both
R / FRT- AXLE SHAFT – Remove & Replace – Right One Side, remove spindle
John C. gave our service a 5 star review on 6/29/2021
2015 Ford Expedition
Mileage
162,447
Service Date
6/28/2021
Services Performed
Inspected vehicle on hoist and checked ac system pressure and found it much higher than spec. Recoved ac system charge and found it slightly below spec. Removed and inspected ac expansion valve as these are know to have issues and found minor debris inside. Replaced valve, charged system to spec and found ac system still had higher pressure than spec. Further inspection revealed a faulty low speed cooling fan that was inop at times causing only the high speed fans to operate. Replaced cooling fan assembly and now found the low speed cooling fans operational while ac is on, and system pressures back in spec.
Mounted onto firewall of vehicle.Had metal shavings inside valve after inspecting.
Service air conditioner. Check condition of all belts and lines. Evacuate and recharge with reclaimed R-134. Test system performance and add dye tracer for possible future leaks in system.
Confirmed customer complaint and gained access to ignition key cylinder/ ignition switch. Was able to tap on key cylinder and the chime would go away. Removed ignition key cylinder and found the chime would still go off at times. Further inspection revealed a worn out ignition switch which sits behind the key cylinder and was causing the chime. Replaced the ignition switch and found the chime now gone with the ignition key out.
IGNITION SWITCH- Remove & Replace
ELECTRIC FAN MOTOR – Remove & Replace
Mike K. gave our service a 5 star review on 6/29/2021
2015 Honda Civic
Mileage
79,436
Service Date
6/22/2021
Services Performed
4 Wheel Alignment. Warranty-30 Days.
INTSALL BATTERY
Edmond H. gave our service a 5 star review on 6/22/2021
2008 Dodge Avenger
Mileage
63,575
Service Date
6/11/2021
Services Performed
Changed Motor Oil & Replaced Filter, Added 4 QTS Blended Motor Oil, Lube Chassis, Check all Fluid Levels
Rotate Tires
CK ROARING NOISE WHILE DRIVING POSS BEARING
FRT WHEEL HUB BEARING – Remove & Replace – Front,Both Sides –
Bob S. gave our service a 5 star review on 6/12/2021
2005 Cadillac Escalade ESV
Mileage
74,393
Service Date
6/8/2021
Services Performed
CK ROARING / WHINING AT 20MPH OFF THE GAS
RING GEAR & PINION – Remove & Replace – [Includes: Replace Pinion Bearings.]
Dan C. gave our service a 5 star review on 6/8/2021
2011 Infiniti M37
Mileage
120,593
Service Date
5/27/2021
Services Performed
Test drove vehicle and confirmed excess noise over bumps. Inspected vehicle on hoist and found worn front struts and stabilizer links. All other suspension components felt ok at this time. Suggest replacing worn front struts and stabilizer links along with alignment.
SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – AWD Both – [DOES NOT include alignment.]
STABILIZER BAR CONTROL LINK – Remove & Replace – Both
TWO Wheel Alignment. Warranty-30 Days
Inspected climate control fan assembly under passenger seat and found the assembly worn out and due for replacement. Replaced fan assembly and found the noise and vibration gone.
SEAT BLOWER ASSEMBLY – Remove & Replace
Antjuan C. gave our service a 5 star review on 6/8/2021
2015 Chevrolet Equinox
Mileage
73,162
Service Date
6/2/2021
Services Performed
CK WIPERS INOPP
WIPER TRANSMISSION – Remove & Replace
CK NOISE IN FRT ON BUMPS ALSO BOUNCEY
CONTROL ARM – Remove & Replace – Lower,Both – [DOES NOT include alignment.]
SHOCK ABSORBER – Remove & Replace – Both – [Includes: R&I Fender Liner.]
TWO Wheel Alignment. Warranty-30 Days
BOTH ARE DIRTY NEED REPLACING
Rotate Tires
Vincent B. gave our service a 5 star review on 6/2/2021
2018 Jeep Compass
Mileage
21,533
Service Date
5/25/2021
Services Performed
STABILIZER BAR END LINK – Remove & Replace – Both Sides
VERIFIED CUSTOMERS CONCERN AND FOUND KNOCKING OVER BUMPS.
Linda D. gave our service a 5 star review on 5/25/2021

CRM Mitchell1

We Service and Repair all CRM Mitchell1 cars