Call (708) 385-1900

Custom

GMC

/GMC

We Service and Repair Most GMC Cars and Trucks

2008 GMC Envoy

2022-09-03T22:03:14+00:00

GMC Envoy

Mileage
167,900
Service Date
9/2/2022
Services Performed
  • Test Drove Vehicle..No Sound In Reverse….Ran Truck In Air And Found Noise From Left Rear Brake Pad Wear Sensor…Needs New Brakes. Also Heard Power Steering Whine And Noise From Belts…Exhaust Manifold Noisy Also…JW
  • AFTER DIAG FOUND ALL SENSORS HAD A SIGNAL EXCEPT PASSENGER FRONT RECOMMEND REPLACING AND RE-CALIBRATING SYSTEM.
  • INSTALL RIGHT FRT TPMS SENSOR
  • INSTALL REAR PADS / ROTORS
 
Adam / Dan / Adam H. gave our service a 5 star review on 9/2/2022
2008 GMC Envoy 2022-09-03T22:03:14+00:00

2006 GMC Envoy

2022-09-02T21:59:22+00:00

GMC Envoy

Mileage
212,830
Service Date
8/31/2022
Services Performed
  • AFTER DIAG FOUND STEERING COOLER SPRAYING FLUID REC REPLACING AND RECHECKING SYSTEM.
  • DEGREASE / CLEAN
  • POWER STEERING FLUID COOLER – Remove & Replace – In-Line6 – [DOES NOT include Cooler Pipes.]
  • Flush Power Steering Fluid
 
John C. gave our service a 5 star review on 9/1/2022
2006 GMC Envoy 2022-09-02T21:59:22+00:00

2005 GMC Savana

2022-08-14T21:59:00+00:00

GMC Savana

Mileage
190,963
Service Date
8/9/2022
Services Performed
  • CK DRIVESHAFT BROKEN TOWED BY CUSTOMER
  • INSTALL NEW DRIVESHAFT
 
Jerry P. gave our service a 5 star review on 8/13/2022
2005 GMC Savana 2022-08-14T21:59:00+00:00

2017 GMC Terrain

2022-03-19T22:01:10+00:00

GMC Terrain

Mileage
45,817
Service Date
3/16/2022
Services Performed
  • after checking all brakes found fronts look like they we're just done not long ago still good,Rears are worn rotors are slightly rust pitted appear to be original rec replacing as a starting point for customers noise concerns.Also test drove vehicle twice and could duplicate any noise issue at this time.
  • AFTER DIAG AND CHECKING ALL SENSORS FOR SIGNAL FOUND ALL ARE WORKING. WE THEN CHECKED AIR IN ALL TIRES FOUND ALL TIRES HAD DIFFERANT AMOUNTS OF AIR ALSO L/R TIRE HAD NAIL PUNCTURE WE REPAIRED TIRE AND CALIBRATED ALL SENSORS LIGHT IS OUT AS OF NOW. AND SET AIR PSI.
  • Remove Tire from Vehicle, Inspect & Repair as Nec.
  • FOUND DIRTY DURING VEHICLE INSPECTION.
 
Diane M. gave our service a 5 star review on 3/18/2022
2017 GMC Terrain 2022-03-19T22:01:10+00:00

2004 GMC Sierra

2022-01-19T23:04:32+00:00

GMC Sierra

Mileage
479,776
Service Date
1/18/2022
Services Performed
  • Vibration From 40-68 mph—Had Driveshaft Center Bearing Replaced Recently (Thats When It Started)
  • PROPELLER SHAFT – Remove & Install or Remove & Replace – Two Piece Driveline,To Rear Axle,Assembly
 
Bruce C. gave our service a 5 star review on 1/18/2022
2004 GMC Sierra 2022-01-19T23:04:32+00:00

2006 GMC Envoy

2021-06-30T22:01:42+00:00

GMC Envoy

Mileage
206,134
Service Date
6/28/2021
Services Performed
  • Test drove vehicle and inspected on hoist. Was unable to duplicate customer concern of clicking on turns while on test drive. Found the RF axle appeared to be worn out and had junk yard type markings on the axle. Recommend replacement of axle and recheck for clicking noises on turns.
  • Changed Motor Oil & Replaced Filter, Added 4 QTS Synthetic Motor Oil, Lube Chassis, Check all Fluid Levels
  • Rotate Tires
  • Test drove vehicle and inspected on hoist. Check engine light was not on at time of inspection. Scanned for codes and found P0014- exhaust camshaft position system performance. Inspected circuits and connections and found no faults. Inspected engine oil level and condition and found engine oil level was ok, was black in color and due for replacement. Tested and found proper power and grounds to camshaft actuator. Removed actuator and found debris on oil inlet screens. Recommend replacement of camshaft position actuator, changing engine oil and filter, clearing codes, and rechecking system operation.
  • VARIABLE VALVE TIMING SOLENOID – Remove & Replace – In-Line6 – [NOTE: Labor estimates listed are for R&R only and DOES NOT include diagnosis time.]
  • The Carbon Clean System is a technologically advanced method for cleaning and de-carbonizing harmful fuel system contaminants from gasoline engines,Clean Throttle body And Fuel Tank Additive.
  • INSTALL FRT PADS / ROTORS
  • INSTALL REAR PADS / ROTORS
  • SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – Both – [DOES NOT include disassemble or alignment (where applicable).]
  • REAR SHOCK ABSORBER – Remove & Replace – Both
  • R / FRT- AXLE SHAFT – Remove & Replace – Right One Side, remove spindle
 
John C. gave our service a 5 star review on 6/29/2021
2006 GMC Envoy 2021-06-30T22:01:42+00:00

2004 GMC Yukon XL

2020-01-30T23:01:30+00:00

GMC Yukon XL

Mileage
160,522
Service Date
1/29/2020
Services Performed
  • CK THUMPING NOISE IN REAR WHEN ACCELARATING AFTER WARMED UP,,
  • INSTALL JOINTS TO SHAFT
  • PROPELLER SHAFT – Remove & Install or Remove & Replace – One Piece Driveline,To Rear Axle
  • Straighten & Balance Driveshaft
 
Keith T. gave our service a 5 star review on 1/29/2020
2004 GMC Yukon XL 2020-01-30T23:01:30+00:00

2008 GMC Yukon XL

2019-01-12T23:00:17+00:00

GMC Yukon XL

Mileage
198,300
Service Date
1/10/2019
Services Performed
  • CK BRAKES GRINDING
  • Changed Motor Oil and Replaced Filter, Added 4 QTS Blended Motor Oil, Lube Chassis, Check all Fluid Levels
  • INSTALL FRONT PADS / ROTORS
  • INSTALL REAR PADS / ROTORS /CALIPERS
  • TRANSFER CASE FLUID EXCHANGE
  • courtesy tire rotation
 
Bob A. gave our service a 5 star review on 1/11/2019
2008 GMC Yukon XL 2019-01-12T23:00:17+00:00

2011 GMC Acadia

2018-10-05T22:01:37+00:00

GMC Acadia

Mileage
82,916
Service Date
10/3/2018
Services Performed
  • Rotate Tires
  • INSTALL CUSTOMERS OIL AND FILTER
 
Tim Q. gave our service a 5 star review on 10/4/2018
2011 GMC Acadia 2018-10-05T22:01:37+00:00