JSON-LD markup generated by Google Structured Data Markup Helper.

Call (708) 385-1900

Go to…

CRM Mitchell1

Home / Archives for CRM Mitchell1 / Page 62

We Service and Repair all CRM Mitchell1 cars

  • 2005 Toyota Prius

    Toyota Prius
    Mileage
    118,881
    Service Date
    11/8/2018
    Services Performed
    • Changed Motor Oil and Replaced Filter, Added 4 QTS Synthetic Motor Oil, Lube Chassis, Check all Fluid Levels
     
    Michael Q. gave our service a 5 star review on 11/9/2018

  • 2006 Chevrolet Malibu

    Chevrolet Malibu
    Mileage
    78,031
    Service Date
    11/7/2018
    Services Performed
    • Changed Motor Oil and Replaced Filter, Added 4 QTS Blended Motor Oil, Lube Chassis, Check all Fluid Levels
     
    TOM K. gave our service a 5 star review on 11/7/2018

  • 2004 Kia Sorento

    Kia Sorento
    Mileage
    130,195
    Service Date
    11/6/2018
    Services Performed
    • Test drove and inspected vehicle. Scanned for codes and found p0128- coolant thermostat (below regulating temp). Inspected cooling system level and condition and found no faults. Cleared code and let vehicle run to normal operating temp while watching data with scan tool and the vehicle seemed to warm up normally within normal timeframe . This vehicle just had a t-stat installed at another shop. If this code returns we will have to start over with replacing the t-stat with a known quality part, as it is unknown if a quality, correct part has been installed. Also noticed the vehicle has a rough idle and a running problem that causes it to die out at times while at idle. Further diag would have to be performed to determine the cause.
     
    Diane and Bob R. gave our service a 5 star review on 11/8/2018

  • 2014 Kia Forte

    Kia Forte
    Mileage
    97,122
    Service Date
    11/6/2018
    Services Performed
    • Inspected vehicle on hoist. Confirmed no-start condition. Scanned for codes and found p0075- intake valve control circuit bank 1. Inspected sensor circuits and connections and found no faults. Removed sensor for inspection and found sensor resistance out of spec and a small amount of metallic debris on screen of sensor. Replaced sensor and cleared codes. After vehicle started up noticed the engine has a knock type noise while running. Inspected engine oil level and condition and found to be ok. Customer gave ok to remove valve cover to inspect upper engine for damage and found the timing chain appeared to have excess slack, but no other engine damage was visable. The engine knock seems loudest from the oil pan area, suggesting a possible rod knock. Engine replacement is recommended.
    • INSTALL OIL INTAKE SOLENOID
    • VALVE COVER GASKET – Remove and Replace – All Applicable Models to inspect engine internals for noise issue after starting
     
    Ashley J. gave our service a 5 star review on 11/6/2018

  • 2013 Nissan Altima

    Nissan Altima
    Mileage
    74,861
    Service Date
    10/29/2018
    Services Performed
    • Changed Motor Oil and Replaced Filter, Added 4 QTS Blended Motor Oil, Lube Chassis, Check all Fluid Levels
     
    Herman / Kim D. gave our service a 5 star review on 10/29/2018

  • 2011 Chevrolet Equinox

    Chevrolet Equinox
    Mileage
    97,058
    Service Date
    10/17/2018
    Services Performed
    • INSTALL BLEND DOOR MOTOR
    • CK NO HEAT CONDITIONS
    • Changed Motor Oil and Replaced Filter, Added 4 QTS Blended Motor Oil, Lube Chassis, Check all Fluid Levels
    • INSTALL FILTERS
     
    Tina L. gave our service a 5 star review on 10/20/2018

  • 2008 Ford Pickup

    Ford Pickup
    Mileage
    167,968
    Service Date
    10/16/2018
    Services Performed
    • TWO Wheel Alignment. Warranty-30 Days
     
    Peter M. gave our service a 5 star review on 10/19/2018

  • 2006 Dodge Charger

    Dodge Charger
    Mileage
    151,306
    Service Date
    10/15/2018
    Services Performed
    • ck vibration on take of right rear up to 10mph then goes away faster you go.
    • PROPELLER SHAFT – Removal and Installation – All Applicable Models – [Includes: R and I Exhaust System.]
    • CENTER SUPPORT BEARING – Remove and Replace – All Applicable Models
    • INSTALL R/SIDE OUTER TIEROD
    • TWO Wheel Alignment. Warranty-30 Days
     
    Tim L. gave our service a 5 star review on 10/20/2018

  • 2011 Toyota Camry

    Toyota Camry
    Mileage
    140,645
    Service Date
    10/17/2018
    Services Performed
    • after diag found timing solenoid giving weak signal causing vehicle to die at idle speeds recomend replacing.
    • INSTALL VVT TIMING SOLENOID
     
    Spero S. gave our service a 5 star review on 10/18/2018

  • 2004 Chevrolet Astro

    Chevrolet Astro
    Mileage
    252,845
    Service Date
    10/10/2018
    Services Performed
    • CK DRIVE SHAFT FOR BALANCE
    • PROPELLER SHAFT – Removal and Installation – AWD Rear,To Rear Axle
    • Straighten and Balance Driveshaft
     
    LORETTA P. gave our service a 5 star review on 10/18/2018