CRM Mitchell1, Author at Chicago Driveline Inc

2015 Jeep Patriot
Mileage
64,387
Service Date
2/14/2023
Services Performed
Changed Motor Oil & Replaced Filter, Added 4 QTS Premium Motor Oil, Lube Chassis, Check all Fluid Levels
rotate tires
Stephanie R. gave our service a 5 star review on 2/14/2023
2016 Honda CR-V
Mileage
52,647
Service Date
2/2/2023
Services Performed
Road test vehicle and confirmed customer complaint. Inspected vehicle on hoist and while running vehicle in air used mechanic stethoscope to listen to different drivetrain components and found noise from right rear wheel bearing. Also found minor noise from left rear wheel bearing. Recommend replacing both rear wheel bearings and rechecking for noise.
WHEEL BEARING – Remove & Replace – FWD Rear,Both – [Includes: Replace Inner and/or Outer Bearings, Cups, Seals and repack (where applicable).]
Frank O. gave our service a 5 star review on 2/14/2023
2004 Jeep Grand Cherokee
Mileage
72,774
Service Date
2/10/2023
Services Performed
Changed Motor Oil & Replaced Filter, Added 4 QTS Synthetic Motor Oil, Lube Chassis, Check all Fluid Levels
DOOR MIRROR – Remove & Replace – Power – [DOES NOT include refinishing (where applicable).]
Check Trans Fliud
replace Rear Wiper Arm
CHECK EXHAUST LEAK
INSTALL MUFF & TAIL PIPE
install battery (WARRANTY)
INSTALL NEW AIR FILTER
PART DISCONTINUED FROM DEALERSHIP
INSTALL R/S WASHER NOZZ
INSTALL TAG LIGHTS
Diane & Bob R. gave our service a 5 star review on 2/11/2023
2011 Honda CR-V
Mileage
53,435
Service Date
2/10/2023
Services Performed
4 Wheel Alignment. Warranty-30 Days.
Rotate Tires TIRES DRY ROTTED
Laurie / Bill E. gave our service a 5 star review on 2/10/2023
2011 Chevrolet Silverado
Mileage
115,775
Service Date
2/10/2023
Services Performed
CK HUMMING NOISE ALSO PULLS R/SIDE
RING GEAR & PINION – Remove & Replace – 2500 HD,3500 HD
When installing a new ring and pinion it is recommended to properly break in the new components. The proper break in procedure will extend the life of the components and help with the prevention of premature failure usually caused by extreme heat. Although your new ring and pinion is “Lapped” from the factory for smooth quiet operation, they will still need to be broken in once they have been installed. A new ring and pinion will initially run hotter when new and can cause extensive damage if the temperature exceeds ideal operating conditions for an extended period of time. The suggested break in procedure is as follows, The first drive with the new ring and pinion should be under normal driving conditions (No hard starts, No racing, No off-roading, No towing and not at Highway speeds). The vehicle should be driven 15-20 minutes around town, normal stop and go driving. Then you should let the axle assembly “Completely Cool” (this will allow the gear oil to cool down so it does not reach temperatures that will break down the oil, causing loss of protection) Repeat the 10-15 minute drive and cooling off period 2-3 times Then you will want to drive on the highway and repeat the process at least 2 times abiding by local speed laws but not exceeding 65 MPH, be sure to let the axle assembly completely cool between drives (very important). Lastly you will want to change the gear oil after the initial 500-1000 miles and your gears are broken in correctly. Note: If vehicle will be used for towing, repeat the break in procedure the first time it is used to tow. Follow the factory service manual for recommended differential service intervals unless the vehicle is used in extreme conditions on a regular basis, you will want to service the differential more often. (Recommended gear oil is an 80W-90 or 85W-140, Non-Synthetic, GL5 grade or Higher, Name Brand Oil. Please note extreme weather conditions may require alternative weight oil so be sure to consult a local mechanic or lube technician for recommendations)
BRIAN A. gave our service a 5 star review on 2/10/2023
2016 Jeep Wrangler
Mileage
93,767
Service Date
2/8/2023
Services Performed
Inspected vehicle on hoist and found front driveshaft severely damaged and ready to fall out. Inspected suspension and found worn parts in front and rear. Customer approved front driveshaft replacement only. Suggest quality 4×4 shop such as Alpha Auto Repair for suspension component replacement as some worn parts are after market lift kit parts that are special order.
<<<<NO WARRANTY ON LIFTED VEHICLE>>>>
ORIGINAL SHAFT DAMAGED TO BADLY.
LONNIE G. gave our service a 5 star review on 2/8/2023
2013 Nissan Sentra
Mileage
48,258
Service Date
1/26/2023
Services Performed
Checked for cable movement at trans and all is hooked up and working proper. Needs new transmission. Check dealer for warranty. Called Nissan vehicle has no warranty.
TRANSAXLE ASSEMBLY – Removal & Installation – Automatic CVT Trans w/o Powertrain Assembly Removal – [DOES NOT include wheel alignment.]
DEALER PROGRAMMING UNIT
Lorraine / Hugh O. gave our service a 5 star review on 1/28/2023
2011 Honda CR-V
Mileage
268,324
Service Date
1/25/2023
Services Performed
WE TEST DROVE VEHICLE EVERYTHING IS WORKING PROPERLY ALSO WE HAD TWO OTHER TECH'S DRIVE VEHICLE AND THEY CONFIRMED VEHICLE RIDES NORMAL.
Desiree Y. gave our service a 5 star review on 1/25/2023
2012 Ford Focus
Mileage
148,451
Service Date
1/25/2023
Services Performed
P0301 In Memory…Remove Plug And Coil And Inspect….Found Cyl # 1 Spark Plug Worn…Rec Plugs,Coils And Fuel Clean…Will Check Compression If Nec….JW
Changed Motor Oil & Replaced Filter, Added 5 QTS Synthetic Motor Oil, Lube Chassis, Check all Fluid Levels
SPARK PLUGS – Remove & Replace – Normally Aspirated
The Carbon Clean System is a technologically advanced method for cleaning and de-carbonizing harmful fuel system contaminants from gasoline engines,Clean Throttle body And Fuel Tank Additive.
George A. gave our service a 5 star review on 1/25/2023
2014 Chevrolet Cruze
Mileage
286,834
Service Date
1/20/2023
Services Performed
BLOWER MOTOR ASSEMBLY – Remove & Replace – [Includes: R&I Glove Box.]
Changed Motor Oil & Replaced Filter, Added 4 QTS Blended Motor Oil, Lube Chassis, Check all Fluid Levels
OXYGEN SENSOR – Remove & Replace upstream also purge valve for evap system.
Chris D. gave our service a 5 star review on 1/20/2023

CRM Mitchell1

We Service and Repair all CRM Mitchell1 cars