Call (708) 385-1900

Custom

Chevrolet

/Chevrolet

We Service and Repair All Chevrolet Cars

2012 Chevrolet Impala

2023-06-20T22:02:49+00:00

Chevrolet Impala

Mileage
126,939
Service Date
6/19/2023
Services Performed
  • CK COOLANT LEAKING
  • CK SUSPENSION SQUEAKING IN REAR ON BUMPS
  • install rear sway bar bushings / warranty stab links
  • POWER SEAT SWITCH – Remove & Replace – Each
 
Bruce G. gave our service a 5 star review on 6/19/2023
2012 Chevrolet Impala 2023-06-20T22:02:49+00:00

2010 Chevrolet Avalanche

2023-06-20T22:01:52+00:00

Chevrolet Avalanche

Mileage
168,157
Service Date
6/19/2023
Services Performed
  • AFTER DIAG FOUND CODES # C0575, C0580 , C0711 ALL REGARDING WIRING FOR AIR RIDE, WE ALSO FOUND SKETCHY WIRING DONE WHEN INSTALL AIR RIDE CONVERSION KIT. INSPECTED ALL 4 CORNERS OF VEHICLE. RECOMMEND TAKE BACK TO WHOM INSTALLED STRUTMASTERS CONVERSION KIT CAUSING THESE CODES TO APPEAR IN VEHICLE SYSTEM.
 
SAMUEL S. gave our service a 5 star review on 6/19/2023
2010 Chevrolet Avalanche 2023-06-20T22:01:52+00:00

2020 Chevrolet Traverse

2023-06-03T22:03:13+00:00

Chevrolet Traverse

Mileage
66,047
Service Date
6/2/2023
Services Performed
  • SUSPENSION KNUCKLE – Remove & Replace – 4WD One Side – [DOES NOT include alignment.]
  • 4 Wheel Alignment. Warranty-30 Days.
 
George/Tina S. gave our service a 5 star review on 6/2/2023
2020 Chevrolet Traverse 2023-06-03T22:03:13+00:00

2012 Chevrolet Silverado

2023-04-10T21:57:42+00:00

Chevrolet Silverado

Mileage
192,684
Service Date
4/4/2023
Services Performed
  • REPLACED ORING WASHER ON TRANS LINE WARRANTY
  • Changed Motor Oil & Replaced Filter, Added 4 QTS Synthetic Motor Oil, Lube Chassis, Check all Fluid Levels
 
Tony D. gave our service a 5 star review on 4/9/2023
2012 Chevrolet Silverado 2023-04-10T21:57:42+00:00

2011 Chevrolet Silverado

2023-04-06T22:01:42+00:00

Chevrolet Silverado

Mileage
116,201
Service Date
4/5/2023
Services Performed
  • 500 MILE DRAIN / FILL REAR DIFFERENTIAL FLUID
 
Brian A. gave our service a 5 star review on 4/5/2023
2011 Chevrolet Silverado 2023-04-06T22:01:42+00:00

2012 Chevrolet Impala

2023-03-22T22:01:47+00:00

Chevrolet Impala

Mileage
123,555
Service Date
3/21/2023
Services Performed
  • Changed Motor Oil & Replaced Filter, Added 4 QTS Blended Motor Oil, Lube Chassis, Check all Fluid Levels
  • INSTALL EXHAUST RESONATOR PIPE
 
Bruce G. gave our service a 5 star review on 3/21/2023
2012 Chevrolet Impala 2023-03-22T22:01:47+00:00

2007 Chevrolet Tahoe

2023-02-22T23:01:31+00:00

Chevrolet Tahoe

Mileage
78,026
Service Date
2/21/2023
Services Performed
  • CK FOR FUEL LEAKS CUSTOMER SMELLS GAS POSS FUEL PUMP ROTTED ON TOP.
  • FUEL PUMP – Remove & Replace
  • CK BRAKES VEHICLE BEEN SITTING IN STORAGE
  • INSTALL REAR PADS / ROTORS
  • Replace Air Filter
  • Replace Front Differential Fluid
  • Drain / Fill
 
Luis B. gave our service a 5 star review on 2/21/2023
2007 Chevrolet Tahoe 2023-02-22T23:01:31+00:00

2011 Chevrolet Silverado

2023-02-11T23:03:00+00:00

Chevrolet Silverado

Mileage
115,775
Service Date
2/10/2023
Services Performed
  • CK HUMMING NOISE ALSO PULLS R/SIDE
  • RING GEAR & PINION – Remove & Replace – 2500 HD,3500 HD
  • When installing a new ring and pinion it is recommended to properly break in the new components. The proper break in procedure will extend the life of the components and help with the prevention of premature failure usually caused by extreme heat. Although your new ring and pinion is “Lapped” from the factory for smooth quiet operation, they will still need to be broken in once they have been installed. A new ring and pinion will initially run hotter when new and can cause extensive damage if the temperature exceeds ideal operating conditions for an extended period of time. The suggested break in procedure is as follows, The first drive with the new ring and pinion should be under normal driving conditions (No hard starts, No racing, No off-roading, No towing and not at Highway speeds). The vehicle should be driven 15-20 minutes around town, normal stop and go driving. Then you should let the axle assembly “Completely Cool” (this will allow the gear oil to cool down so it does not reach temperatures that will break down the oil, causing loss of protection) Repeat the 10-15 minute drive and cooling off period 2-3 times Then you will want to drive on the highway and repeat the process at least 2 times abiding by local speed laws but not exceeding 65 MPH, be sure to let the axle assembly completely cool between drives (very important). Lastly you will want to change the gear oil after the initial 500-1000 miles and your gears are broken in correctly. Note: If vehicle will be used for towing, repeat the break in procedure the first time it is used to tow. Follow the factory service manual for recommended differential service intervals unless the vehicle is used in extreme conditions on a regular basis, you will want to service the differential more often. (Recommended gear oil is an 80W-90 or 85W-140, Non-Synthetic, GL5 grade or Higher, Name Brand Oil. Please note extreme weather conditions may require alternative weight oil so be sure to consult a local mechanic or lube technician for recommendations)
 
BRIAN A. gave our service a 5 star review on 2/10/2023
2011 Chevrolet Silverado 2023-02-11T23:03:00+00:00

2014 Chevrolet Cruze

2023-01-21T23:02:34+00:00

Chevrolet Cruze

Mileage
286,834
Service Date
1/20/2023
Services Performed
  • BLOWER MOTOR ASSEMBLY – Remove & Replace – [Includes: R&I Glove Box.]
  • Changed Motor Oil & Replaced Filter, Added 4 QTS Blended Motor Oil, Lube Chassis, Check all Fluid Levels
  • OXYGEN SENSOR – Remove & Replace upstream also purge valve for evap system.
 
Chris D. gave our service a 5 star review on 1/20/2023
2014 Chevrolet Cruze 2023-01-21T23:02:34+00:00

2008 Chevrolet Suburban

2023-01-19T23:01:11+00:00

Chevrolet Suburban

Mileage
192,033
Service Date
1/18/2023
Services Performed
  • COULD NOT DUPLICATE CUSTOMERS CONCERN AT THIS TIME RAINING OUTSIDE NOISES VERY WHEN ROADS ARE WET.
  • Road tested vehicle and confirmed customer complaint. Inspected vehicle on hoist and found rear driveshaft u- joints worn out and due for replacement.
  • PROPELLER SHAFT – Remove & Install or Remove & Replace – 4WD To Rear Axle
  • install joints to shaft
  • Straighten & Balance Driveshaft
  • Scanned for codes and found P0442- EVAP emission system small leak detected. Inspected related circuits and connections and found no faults. Tested purge valve and found it not completely sealing when commanded. Performed evap system smoke test and found system not holding pressure. Further diag revealed a rotted fuel pump causing the system to loose pressure. Suggest replacing purge valve, along with the fuel pump and any needed fuel lines, then rechecking system operation.
  • FUEL PUMP – Remove & Replace – C1500,K1500
  • EVAPORATIVE CANISTER PURGE SOLENOID – Remove & Replace
 
Brian O. gave our service a 5 star review on 1/18/2023
2008 Chevrolet Suburban 2023-01-19T23:01:11+00:00